Jump to content

MPCD/UHD Problems


Vannipo

Recommended Posts

Hi.

 

I really like all my maps in my life North-Up. I like that mode on my NAVI in my car, too. It's better for me to understand the environment.

 

  1. If I switch the map to N-up, neither the TDC input in DATA-Mode is useable, cause of a rotated input, nor the outer TACAN-Bearing is rotated, but stays @ the wrong angle.
     
  2. The Auto-Zoom mode is buggy. Positions of e.g. waypoints are moving.
     
  3. Why is it not possible to set a CRS in AWLS mode? That would make it easier to align on final approach-vector. I always have to toggle to TACAN-Mode to check my alignement.
     
  4. For me, it was not possible to add ID19 to the "AN_ARN128_config.lua". If I coose AWLS->19->Enter. It jumps back to the previous value.
     
    Wanted to add:
    awls_channels[19] = {}
    awls_channels[19]["name"] = "Khasab"
    awls_channels[19]["runway"] = "19"
    awls_channels[19]["ils_freq"] = 110.30
    awls_channels[19]["tacan_ch"] = 84
    awls_channels[19]["tacan_xymod"] = 0
    awls_channels[19]["ils_gs"] = 3.0
    awls_channels[19]["ils_az_os"] = 0
    awls_channels[19]["ils_el_os"] = 0

    But putting this at position e.g. 5 works
     
  5. At some airfields with ILS, I cant get a vector. E.g. Sochi-Adler.

 

Maybe some of u, can give me a hand, if it's just me. :)

 

Regards

Vannipo


Edited by Vannipo
Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...