tangodownNZ Posted October 21, 2017 Share Posted October 21, 2017 Hi all, I just got a pair of Saitek combat pedals but there is a fault. The driver loaded automatically and the rudder works fine in DCS. However when I try to use the toe brakes they move the flight stick and not toe brakes. Is there a fix for this. Link to comment Share on other sites More sharing options...
hannibal Posted October 21, 2017 Share Posted October 21, 2017 http://www.saitek.com/uk/down/drivers.php clear all axis commands for each plane and also set toe brakes as slider for the axis tune find me on steam! username: Hannibal_A101A http://steamcommunity.com/profiles/76561197969447179 Link to comment Share on other sites More sharing options...
tangodownNZ Posted October 21, 2017 Author Share Posted October 21, 2017 (edited) I really appreciate that mate. The driver link you provided was very good, it works alot better. Edited October 21, 2017 by tangodownNZ Link to comment Share on other sites More sharing options...
Sokol1_br Posted October 21, 2017 Share Posted October 21, 2017 The driver loaded automatically and the rudder works fine in DCS. However when I try to use the toe brakes they move the flight stick and not toe brakes. Is there a fix for this. This is not driver issue or fault, but happens due the fact that DCS automatically assign funcions for new controller axes - not always correctly, so the brakes pedals are assigned for Aileron and Elevator under Saitek Pedal name in Controls tab and this take preference over joystick (probable lower ID), just delete this assignments, and assign the pedal brake axis for "Wheel Brake Right " and "Wheel Brake Left". Link to comment Share on other sites More sharing options...
Recommended Posts