-archer- Posted June 23, 2018 Share Posted June 23, 2018 Greetings gentlemen! I'd like to clarify a question: is there any section in configuration files of a module (e.g. F/A-18C) - where I could set a position (a value of range) of the throttle grip - to set afterburner on (or - to set cutoff position)? For example, I have a throttle levers that can move within a range of 100 mm. I want to configure a value at 90% of the range - to turn on the afterburner. By now, as I informed, it can be done via axes curves settings. However I want to find out - may be there is more precise way to set the position? Like it can be done in advanced models in MSFS (Prepar3D), like Majestic Dash 8 Q 400 Pro.. i7-6700k (4.7 GHz) // RAM 32 Gb // GTX 1070 // // Windows 10 64-bit LTSB; VKB Gunfighter Mk2 Pro + VKB MCG Pro // BRD-F1(v.2) // Oculus Rift cv1 // BRD-N(v. №4) // VKB King Cobra MkII Fat // VKB King Cobra MkIII Fat // Saitek X55 // Saitek throttle Quadrant // Microsoft FFB 2 // Saitek X45 // Thrustmaster HOTAS Warthog // VKB MK20-3 Pro Pedals // VKB RDRXXI-L // TrackIR 5 Link to comment Share on other sites More sharing options...
some1 Posted June 23, 2018 Share Posted June 23, 2018 Unfortunately not. Curves are the only way. Hardware: VPForce Rhino, FSSB R3 Ultra, Virpil T-50CM, Hotas Warthog, Winwing F15EX, Slaw Rudder, GVL224 Trio Throttle, Thrustmaster MFDs, Saitek Trim wheel, Trackir 5, Quest Pro Link to comment Share on other sites More sharing options...
Recommended Posts