RavenFrost Posted August 15, 2019 Share Posted August 15, 2019 Hy guys, I'm creating a mission and it should end if you succesfully land on the carrier. On airfields i use this: Group X Dead -> set Flag 1; then I set a triggerzone at the parkingslot and if you enter it. then it checks Flag 1 true + Unit in Zone = Mission End. Any ideas how to do this on an aircraftcarrier? [sIGPIC][/sIGPIC] Link to comment Share on other sites More sharing options...
CL30 Posted August 16, 2019 Share Posted August 16, 2019 Well, I'm certainly no expert, but I would try to make a yuuuuge trigger zone that the carrier will remain in during the mission. Then, I would set the trigger so that if the plane is inside zone and moving less than XX knots, that you would get success. Again, that's just how I would start to approach it. There's probably a better way. :) i5-9600k @ 5.0 GHz| Gigabyte Z390 Aorus Master | 32 GB Trident G.Skill RAM @ 3200 MHz | Thermaltake Floe Riing 360 AIO | Samsung EVO 860 500 GB SSD | Crucial MX500 500 GB M.2 | SanDisk 1TB SSD | EVGA RTX 2080 Ti Ultra Gaming | EVGA G3 850W Gold PSU | Thermaltake View 71 TG Snow Edition | Thrustmaster Warthog HOTAS | MFC Crosswind pedals | Oculus Rift-S [sIGPIC][/sIGPIC] Link to comment Share on other sites More sharing options...
Sedlo Posted August 16, 2019 Share Posted August 16, 2019 Create a trigger zone about 1000ft big, and put it in the corner of the map where you won't fly into it.... Then a condition your unit inside the moving zone (the 1000ft one) and make the unit speed less than say 30 kts... That should do the trick. My Youtube Channel MY DCS MISSIONS Link to comment Share on other sites More sharing options...
Recommended Posts