caponi Posted September 26, 2020 Share Posted September 26, 2020 Hi, i did not found any information .... So i try to explain my behaviour. if i lock a target (40nm hot) with ACQ or with TDC depress. The lock was lost after 3 seconds ... I could see that the interleave (hi/med) switched from intlHi to intMed and then into Med. And then the interleave are stopped and the contact was unlocked. if i set the interleave manually to Hi then i can regain and hold the lock. is there a problem with the interleave function ? too much ... Link to comment Share on other sites More sharing options...
Swift. Posted September 26, 2020 Share Posted September 26, 2020 Yeah when PRF is set to INT, it should lock the target usual the same PRF it detected it on, afaik. But currently it is defaulting to MED PRF, which limits it to about 25-30NM, you have to manually set it to HI PRF to lock beyond that 476th Discord | 476th Website | Swift Youtube Ryzen 5800x, RTX 4070ti, 64GB, Quest 2 Link to comment Share on other sites More sharing options...
caponi Posted September 26, 2020 Author Share Posted September 26, 2020 is it a bug or a feature ? :music_whistling: too much ... Link to comment Share on other sites More sharing options...
Swift. Posted September 26, 2020 Share Posted September 26, 2020 is it a bug or a feature ? :music_whistling: Guess, hint: its already reported 476th Discord | 476th Website | Swift Youtube Ryzen 5800x, RTX 4070ti, 64GB, Quest 2 Link to comment Share on other sites More sharing options...
caponi Posted September 26, 2020 Author Share Posted September 26, 2020 thx :thumbup: too much ... Link to comment Share on other sites More sharing options...
EXPENDTripwire Posted September 27, 2020 Share Posted September 27, 2020 Thanks for posting up this question, and swiftwin9s for the answer - this has been bugging me for a long time. Link to comment Share on other sites More sharing options...
Recommended Posts