Single Mission - "In the weeds"

The mission "In The Weeds" for the A10C does not have the JTAC setup correctly and thus the JTAC will not respond when you call for him.

Edited to add that I am reproducing this on 2.5.3 open beta.

To reproduce:

Launch "In the weeds" mission, navigate to IP, call JTAC on FM (L shift + num-) announce playtime.

Expected Result:

JTAC should respond to your calls

Actual Result:

JTAC does not respond

To resolve:

Navigate to mission editor, load the In The Weeds mission

Select JTAC vehicle group

Select #3 WP Action (Set Frequency)

Add a "Power" (I used 10)

Select each FAC Assign Group one at a time

Change callsign to Hammer (to match WP Action #2)

Change frequency to 30

Change modulation to FM

Save mission.

TJ

Apologies this isnt in the "Missions and Campaigns" section of the bug forum - I scrolled down to the M's and saw the "ME issues," "Multi Monitor Displays" and "Multiplayer" and assumed the listing was all in alpha order. It wasnt until after I made this post that I scrolled down and saw the spot for "missions and campaigns" at the very bottom of the otherwise alpha sorted list.

TJ