Wizard1393 Posted June 4, 2020 Share Posted June 4, 2020 So now the radar TDC floor/ceiling numbers change/cycle between every bar scan. Is this a bug? Extremely unuseful and annoying. Hard to quickly review where your radar is looking. It was much better before when the floor value was always taken from the lowest bar scanned and ceiling value was always taken from the highest bar scanned. GPU: PALIT NVIDIA RTX 3080 10GB | CPU: Intel Core i7-9700K @ 4,9GHz | RAM: 64GB DDR4 3000MHz VR: HP Reverb G2 | HOTAS: TM Warthog Throttle and Stick OS: Windows 10 22H2 Link to comment Share on other sites More sharing options...
Wizard1393 Posted June 4, 2020 Author Share Posted June 4, 2020 (edited) TDC radar altitude readout does not update with antenna elevation change - fixed Wait, so this fix, it must be about a bug that prevented the numbers to change then elevation was changed right? Now it cycles on every bar. So if you are in a 4-bar scan you will get 4 different readouts cycling. It CANT be right...right? Edited June 4, 2020 by chrisofsweden GPU: PALIT NVIDIA RTX 3080 10GB | CPU: Intel Core i7-9700K @ 4,9GHz | RAM: 64GB DDR4 3000MHz VR: HP Reverb G2 | HOTAS: TM Warthog Throttle and Stick OS: Windows 10 22H2 Link to comment Share on other sites More sharing options...
Santi871 Posted June 4, 2020 Share Posted June 4, 2020 It's reported/fixed internally :) Link to comment Share on other sites More sharing options...
Wizard1393 Posted June 4, 2020 Author Share Posted June 4, 2020 It's reported/fixed internally :) Ah! Thank you for confirming! No worries then! :thumbup: GPU: PALIT NVIDIA RTX 3080 10GB | CPU: Intel Core i7-9700K @ 4,9GHz | RAM: 64GB DDR4 3000MHz VR: HP Reverb G2 | HOTAS: TM Warthog Throttle and Stick OS: Windows 10 22H2 Link to comment Share on other sites More sharing options...
Recommended Posts