zippoa Posted December 6, 2019 Share Posted December 6, 2019 Maybe in future developers could add exports for only center square region of MFD? And name them for example : LEFT_SQ_MFCD, CENTER_SQ_MFCD, RIGHT_SQ_MFCD These exports would not contain bottom section on MFD that is currently divided by white line. Why I ask for it? Because me and I am sure lot of people use Thrustmaster MFD panels with displays, and it will save lot of time for adjusting export mfd. Thanks! Link to comment Share on other sites More sharing options...
Sephyrius Posted December 6, 2019 Share Posted December 6, 2019 Check out the following : F:\Eagle Dynamics\DCS World OpenBeta\Mods\aircraft\JF-17\Doc\JF-17_3_MFCD.lua But yes, it does require setting up, is it possible for those with TM MFDs to post their Lua files to make it easier for others or is it too highly dependent on your monitor setup? Link to comment Share on other sites More sharing options...
zippoa Posted December 6, 2019 Author Share Posted December 6, 2019 Yes, I saw that file, also saw this topic https://forums.eagle.ru/showthread.php?t=256854 I'll try to do it, but it would be nice if possible to have separate easy usable exports instead of setup all that Link to comment Share on other sites More sharing options...
FZG_Immel Posted December 6, 2019 Share Posted December 6, 2019 Check out the following : F:\Eagle Dynamics\DCS World OpenBeta\Mods\aircraft\JF-17\Doc\JF-17_3_MFCD.lua But yes, it does require setting up, is it possible for those with TM MFDs to post their Lua files to make it easier for others or is it too highly dependent on your monitor setup? this is how you do it https://forums.eagle.ru/showthread.php?t=256854 [sIGPIC]https://forums.eagle.ru/signaturepics/sigpic70550_3.gif[/sIGPIC] Asus Z390-H - SSD M.2 EVO 970 - Intel I9 @5.0ghz - 32gb DDR4 4000 - EVGA 3090 - Cougar FSSB + Virpil WRBRD + Hornet Stick - Thrustmaster TPR Pedal + WinWing MIP + Orion + TO and CO pannels - Track IR5 Link to comment Share on other sites More sharing options...
zippoa Posted December 6, 2019 Author Share Posted December 6, 2019 You posted link that I posted :) Link to comment Share on other sites More sharing options...
Recommended Posts