Speedbrake Posted December 27, 2018 Share Posted December 27, 2018 I was practicing GBU-12 bombing. After I restarted the mission I could not get the laser code to enter. I have the weapon selected, set the mode and fuse but when I went to set the code, I selected code, clicked on it, entered the code and hit enter. The code flashed on the UFC but did not change from 1111 to the 1866 I selected. After a few tries and rebooting the mission I tried again with the same results. I did a DCS beta repair and got the same results. I also tried using AGM-65s which I have done several times before with the same results. Can't set the laser code. Any suggestions? Link to comment Share on other sites More sharing options...
Tholozor Posted December 27, 2018 Share Posted December 27, 2018 Post a track file and we can take a look. REAPER 51 | Tholozor VFA-136 (c.2007): https://www.digitalcombatsimulator.com/en/files/3305981/ Arleigh Burke Destroyer Pack (2020): https://www.digitalcombatsimulator.com/en/files/3313752/ Link to comment Share on other sites More sharing options...
Speedbrake Posted December 27, 2018 Author Share Posted December 27, 2018 DUH!!!!! I feel stupid....I had transposed the code it should have been 1688 not 1866. When I entered the correct code...it took it correctly. I was entering the code on the runway...not when I contacted JFAC. Link to comment Share on other sites More sharing options...
Recommended Posts