Is there a way to disable the center trimmer for a non-FFB, non-centering joystick?

Hello all, I'm planning on picking up a non-FFB, non-centering joystick for use with the Ka-50. Since using the trimmer affects the autopilot, it's important to be able to use this feature. For FFB joysticks, the joystick position is taken as the absolute position of the cyclic (the position of the joystick matches the position of the cyclic in-game).

However, for non-FFB joysticks, the position is taken as the relative position from the virtual cyclic. This means that, for example, if you're holding the joystick at 20X, 20Y and press the trimmer button and continue holding the same position, the game will set the trim to 20X, 20Y, then add in the joystick's position of 20X, 20Y, which leads to an in-game position of 40X, 40Y. This trimmer mode is intended to be used for joysticks that have a centering spring, where you would press the trim button and return the joystick back to center.

But with a non-FFB, non-centering joystick, I'd like the joystick to be taken as the absolute position. Is there a way to get this behavior?

Under special, uncheck "Central positional trimmer mode"? Just a guess. What do I know! :huh:

There is, you'll have to navigate to Mods\aircraft\Ka-50\FM\FMOptions.lua and change line 9 "HelicopterTrimmerTauInverse" to 0.0

This'll be reverted every repair/patch though so turning it into a mod through JSGME is recommended.