TM MFD Issues

Hey All -

Setup:

I run 3 Cougar MFDs. Each are individually identified as F16 MFD 1, 2 & 3. These were initially setup on a previous PC before I upgraded back in October. By "setup" I mean I changed the ID of the 3rd MFD to "3" and changed the indicator LEDs on all panels to Identify them as 1/2/3 so I knew where I wanted them placed.

Problem:

In short, I cannot change the LEDs on MFD 3. TARGET software does not even see MFD 3. I've unplugged all the panels, only had the 3rd one plugged in, switched ports... NADA!

A little more background:

Previously in Windows USB Control Panel I could make whatever changes I wanted to the MFDs. I could change their ID, LED intensity and all of that jazz. I cannot anymore on this new PC... I assume its a new driver windows downloaded. Further, I assume TARGET takes over all of this now. Windows USB Control Panel does see all 3 MFDs, TARGET does not.

Any thoughts? All I want to do is turn off the indicator lights on the 3rd MFD.

Thanks!

Did you manage to get this fixed as I have the same issue