Need help with .lua for MFD extract

PREAMBLE :

Good morning everyone,

I'm new to the forums, but have lurked for a while. I have been playing DCS for a while and own several of the modules and have pre-ordered the supercarrier.

Recently I have taken up getting better peripherals including TM Warthog Throttle/Grip (now upgraded to F/A-18 Grip), MFG pedals, modified Playseat AirForce, Vive Pro (currently on the shelf gathering dust, Cougar MFDs w/ 8" non-touch LCDs, TrackIR, Streamdeck -XL as a multifunction button box.

THE OBJECTIVE :

I tried following several online guides and tutorials on how to get the LCD screens to show the information from the left and right MFDs (F/A-18 ) , several times I got close but I could never get over the last hurdle of making it actually work fully. The closest I cam to it showing up was being able to see the little yellow cross used when turning knobs or pushing buttons in the cockpit.

THE SETUP :

One primary 50" (?) monitor set to 3840x2160 , to 8" (?) LCD screens set to 800x800.

After reading through several posts, tutorials, and watching a couple out-dated videos, I have confused myself as to where the screens need to be set ( in Windows Display Settings), but this is how I have it .

THE REQUEST :

I am looking to commission the creation of a working .LUA file that will allow the export of left and right MFD for the F/A-18 Module. Working with code is not a skill I possess, and will gladly pay for the expertise that someone on this forum must have. Having tried messing with it I can see the difficulty and complication involved and will gladly pay to have the file made. This is skilled work, with time and knowledge involved, and after devoting 12 hours to trying to figure it out and deep personal inflection, they are skills I don't have

THE PAY :

PayPal , electronic transfer, etc. Will be discussed privately with whoever is going to write the .LUA. , to be determined by the file author