Jump to content

Needed...Warthog H.E.A.R.T. sensor assembly


Ericpwp

Recommended Posts

Hello, new to the forum here.

 

I found my way here in search of a solution to an as-is Ebay purchase. I bought a TM Warthog stick and quickly found out why it was as-is. The gimbal was cracked and the whole hall sensor assembly was missing.

 

I was able to 3D print a new gimbal from thingiverse and it worked great.

https://www.thingiverse.com/thing:3366187

 

The bigger problem is the H.E.A.R.T. assembly. It would be great if someone had one laying around that they didn't want anymore :music_whistling:

 

I have searched for an .stl to print the gray base but have come up empty. I could try to create one in freecad if someone could post the measurements. It is the part on the left.

 

technology_174a_022.jpg

 

As for the sensor, I was able to find a t16000m and pull the hall sensor out of it. After some trial and error I was able to wire it to the Warthog and get it working. Now I just have to figure out how to mount it after desoldering it from the board.

 

oNnZq12.jpg

 

It's too big to fit, but it is the same circuit as the Warthog (w/ different wiring order)

 

:helpsmilie:

 

Thanks in advance.

 

Eric

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...