Anatoli-Kagari9 Posted January 29, 2017 Share Posted January 29, 2017 I just got training in my new Gazelle module. I had seen before videos like this: showing some weird ( IMO ) behaviour, but yesterday after completing the startup training mission I decided to lift off by pulling the collective slowly until the Gazelle lifts from ground and enters IGE, and then, without ANY cyclic or anti-torque correction, I climbed all the way up this way, rolling around the vertical axis, with no drift or drag hint or displacement requiring cyclic corrections ... I repeated with the AP and it's three channels disengaged, and the same is possible :-/ Also, the trim options for "left wing down..." and pitch seem swapped ? I programmed a button for left wing down and the heli rolls right, another one for nose down, and the heli pitches up ? Flight Simulation is the Virtual Materialization of a Dream... Link to comment Share on other sites More sharing options...
Holton181 Posted January 29, 2017 Share Posted January 29, 2017 ... Also, the trim options for "left wing down..." and pitch seem swapped ? I programmed a button for left wing down and the heli rolls right, another one for nose down, and the heli pitches up ? Maybe this will help? Read post #19 https://forums.eagle.ru/showthread.php?p=3022043 I don't own this module, just remember reading about a solved similar issue. /H 1 Helicopters and Viggen DCS 1.5.7 and OpenBeta Win7 Pro 64bit i7-3820 3.60GHz P9X79 Pro 32GB GTX 670 2GB VG278H + a Dell PFT Lynx TrackIR 5 Link to comment Share on other sites More sharing options...
Anatoli-Kagari9 Posted January 29, 2017 Author Share Posted January 29, 2017 Thank you So Much Holton! That must be it !!! Still at the cafeteria, reading the manual and browsing the ED and AVSIM forums, but will try it ASAP at home ! Flight Simulation is the Virtual Materialization of a Dream... Link to comment Share on other sites More sharing options...
Holton181 Posted January 29, 2017 Share Posted January 29, 2017 Glad to help, but no cred to me ;-) Helicopters and Viggen DCS 1.5.7 and OpenBeta Win7 Pro 64bit i7-3820 3.60GHz P9X79 Pro 32GB GTX 670 2GB VG278H + a Dell PFT Lynx TrackIR 5 Link to comment Share on other sites More sharing options...
Anatoli-Kagari9 Posted January 29, 2017 Author Share Posted January 29, 2017 (edited) Just tested it - was the FFB enabled in the Game Options, when I do not have one ! But that total lack of need to compensate for collective adjustments, even with SAS and trim OFF, as soon as we get away from near stationary still puzzles me :-/ Is the real Gazelle that "easy" to cope with when collective is lowered / pulled ( even abruptly ) without requiring any sort of anti-torque ( rudder ) input ? To make sure it wasn't the SAS, I turned of the AP and all of the three SAS channels as well as the mag trim, but still no need for rudder input with collective adjustments if I have a fwd movement with just a médium speed. Edited January 29, 2017 by jcomm Flight Simulation is the Virtual Materialization of a Dream... Link to comment Share on other sites More sharing options...
Recommended Posts