Ericpwp Posted December 28, 2019 Share Posted December 28, 2019 Hello, new to the forum here. I found my way here in search of a solution to an as-is Ebay purchase. I bought a TM Warthog stick and quickly found out why it was as-is. The gimbal was cracked and the whole hall sensor assembly was missing. I was able to 3D print a new gimbal from thingiverse and it worked great. https://www.thingiverse.com/thing:3366187 The bigger problem is the H.E.A.R.T. assembly. It would be great if someone had one laying around that they didn't want anymore :music_whistling: I have searched for an .stl to print the gray base but have come up empty. I could try to create one in freecad if someone could post the measurements. It is the part on the left. As for the sensor, I was able to find a t16000m and pull the hall sensor out of it. After some trial and error I was able to wire it to the Warthog and get it working. Now I just have to figure out how to mount it after desoldering it from the board. It's too big to fit, but it is the same circuit as the Warthog (w/ different wiring order) :helpsmilie: Thanks in advance. Eric Link to comment Share on other sites More sharing options...
Recommended Posts