Dav IRL Posted September 13, 2020 Share Posted September 13, 2020 Hi, After a cold start my waypoints are loaded, however the ETA and miles to steerpoint on the bottom right corner of the hud does not show this information, am I missing a step in setting up the aircraft? Thanks, D 4.8 I7, 1080, TMW&T, SSD, VKB MK.IV. Link to comment Share on other sites More sharing options...
Eaglewings Posted September 13, 2020 Share Posted September 13, 2020 (edited) Did you do your INS Alignment properly. Most likely the cause. Edited September 13, 2020 by Eaglewings Windows 10 Pro 64bit|Ryzen 5600 @3.8Ghz|EVGA RTX 3070 XC3 Ultra|Corair vengence 32G DDR4 @3200mhz|MSI B550|Thrustmaster Flightstick| Virpil CM3 Throttle| Thrustmaster TFRP Rudder Pedal /Samsung Odyssey Plus Headset Link to comment Share on other sites More sharing options...
Dav IRL Posted September 13, 2020 Author Share Posted September 13, 2020 I switched it to norm for 4 minutes and then when I went to taxi I switched it to nav Sent from my iPhone using Tapatalk 4.8 I7, 1080, TMW&T, SSD, VKB MK.IV. Link to comment Share on other sites More sharing options...
Eaglewings Posted September 13, 2020 Share Posted September 13, 2020 Before you release parking brake and start taxing, ALIGN needs to start flashing indicating completion of alignment after which you can switch to NAV Check this video by Wagner for a guide INS alignment procedure for the Viper Windows 10 Pro 64bit|Ryzen 5600 @3.8Ghz|EVGA RTX 3070 XC3 Ultra|Corair vengence 32G DDR4 @3200mhz|MSI B550|Thrustmaster Flightstick| Virpil CM3 Throttle| Thrustmaster TFRP Rudder Pedal /Samsung Odyssey Plus Headset Link to comment Share on other sites More sharing options...
Dav IRL Posted September 13, 2020 Author Share Posted September 13, 2020 Awesome thankyou first this Sent from my iPhone using Tapatalk 4.8 I7, 1080, TMW&T, SSD, VKB MK.IV. Link to comment Share on other sites More sharing options...
Dav IRL Posted September 13, 2020 Author Share Posted September 13, 2020 So Wags video has the answer. Basically when you start alignment I wasn’t hitting enter on both starting coordinates Sent from my iPhone using Tapatalk 4.8 I7, 1080, TMW&T, SSD, VKB MK.IV. Link to comment Share on other sites More sharing options...
Recommended Posts