Nume Noctre Posted May 8, 2014 Share Posted May 8, 2014 Hi Folks, I hope someone can help. I have setup a mission with multiple red units and a blue JTAC. The JTAC reports the units in his task, but he also reports units that are set up to be invisible with the advanced waypoint menu. I want the JTAC to provide intel on the targets, but also I want some hidden threats such as man pads and a Sam unit. What am I missing? Thanks for your help! Nume [sIGPIC][/sIGPIC] Check out my channel Link to comment Share on other sites More sharing options...
Sabre-TLA Posted May 8, 2014 Share Posted May 8, 2014 Can you post your mission? Do you use a flag condition check to turn on or off the invisibility option? MapleFlagMissions - Read Our Blog for Updates Link to comment Share on other sites More sharing options...
Nume Noctre Posted May 8, 2014 Author Share Posted May 8, 2014 Hi Sabre, I am not that deep into the ME just yet. All I have done is setting up the units in different groups, then assign two groups as targets for the JTAC. For the other groups I set up a advanced waypoint action: Execute Order -> Invisible I looked it up in the ME manual and it is supposed to hide units from detection. But for some reason the JTAC still reports it in the 9line briefing. ??? Best Alex [sIGPIC][/sIGPIC] Check out my channel Link to comment Share on other sites More sharing options...
Sabre-TLA Posted May 8, 2014 Share Posted May 8, 2014 (edited) Make sure you have both the Enable Flag and Value's checked as indicated below: The Value indicates if it is on or off and the Enable Flag indicates if the action is turned on or not. Edited May 8, 2014 by Sabre-TLA MapleFlagMissions - Read Our Blog for Updates Link to comment Share on other sites More sharing options...
Recommended Posts