eatthis Posted October 12, 2019 Share Posted October 12, 2019 my icls rarely works, im pretty sure its all setup properly, sometimes i get the vertical bar but i rarely get the horizontal bar 7700k @5ghz, 32gb 3200mhz ram, 2080ti, nvme drives, valve index vr Link to comment Share on other sites More sharing options...
Tholozor Posted October 13, 2019 Share Posted October 13, 2019 (edited) Make sure your Steer CMD mode is set to AWL/PCD, if you were on TACAN you would only get the vertical bar. Edited October 13, 2019 by Tholozor changed horizontal to vertical REAPER 51 | Tholozor VFA-136 (c.2007): https://www.digitalcombatsimulator.com/en/files/3305981/ Arleigh Burke Destroyer Pack (2020): https://www.digitalcombatsimulator.com/en/files/3313752/ Link to comment Share on other sites More sharing options...
eatthis Posted October 13, 2019 Author Share Posted October 13, 2019 Make sure your Steer CMD mode is set to AWL/PCD, if you were on TACAN you would only get the horizontal bar. checked that 7700k @5ghz, 32gb 3200mhz ram, 2080ti, nvme drives, valve index vr Link to comment Share on other sites More sharing options...
Tholozor Posted October 13, 2019 Share Posted October 13, 2019 If you fly 1,200ft on the final bearing to the carrier box you should get full needles at 3 miles on glideslope. REAPER 51 | Tholozor VFA-136 (c.2007): https://www.digitalcombatsimulator.com/en/files/3305981/ Arleigh Burke Destroyer Pack (2020): https://www.digitalcombatsimulator.com/en/files/3313752/ Link to comment Share on other sites More sharing options...
eatthis Posted October 13, 2019 Author Share Posted October 13, 2019 If you fly 1,200ft on the final bearing to the carrier box you should get full needles at 3 miles on glideslope. negative, sometimes i get 1 but rarely both 7700k @5ghz, 32gb 3200mhz ram, 2080ti, nvme drives, valve index vr Link to comment Share on other sites More sharing options...
Tholozor Posted October 13, 2019 Share Posted October 13, 2019 Put up a track file then, not sure what the problem is. REAPER 51 | Tholozor VFA-136 (c.2007): https://www.digitalcombatsimulator.com/en/files/3305981/ Arleigh Burke Destroyer Pack (2020): https://www.digitalcombatsimulator.com/en/files/3313752/ Link to comment Share on other sites More sharing options...
Banzaiib Posted October 15, 2019 Share Posted October 15, 2019 data link set to the boat? oh, nm, I'm thinking acls :) Link to comment Share on other sites More sharing options...
Super Grover Posted October 15, 2019 Share Posted October 15, 2019 Also, check if there's only one carrier using ICLS - if there is more, the signal from them may interfere and result in unstable ICLS signal or even make tuning the ICLS impossible. The longer version of this story: it is possible to have multiple carriers using ICLS, but remember to set different channels to the carriers sailing close to each other. Additionally, please remember, that channels that are 10 channels apart share one frequency, so two carriers operating together and using channel 1 and channel 11 respectively will also make ICLS operation disturbed or impossible. Krzysztof Sobczak Heatblur Simulations https://www.facebook.com/heatblur/ Link to comment Share on other sites More sharing options...
Recommended Posts