TeddyThePilot Posted December 21, 2019 Share Posted December 21, 2019 (edited) After switching into ground mode and activate of the aircraft gun, the gun isn't ready. All settings required for ground attack is disabled. This issue is appear in MP only. Also this issue of the gun don't allow to use reticle to hit target, all bullets overfly of ground target. In SP missions all is fine, all settings are enabled and gun reticle work fine. DCS 2.5.5.41371 Edited December 23, 2019 by TeddyThePilot 50+ DCS World mods. Russian Falcons Club Link to comment Share on other sites More sharing options...
AeriaGloria Posted December 21, 2019 Share Posted December 21, 2019 If the problem is only the overflying, your barometric altitude is too low. It does not have AGR mode yet so CCIP is based off barometric altitude Black Shark Den Squadron Member: We are open to new recruits, click here to check us out or apply to join! https://blacksharkden.com Link to comment Share on other sites More sharing options...
TeddyThePilot Posted December 23, 2019 Author Share Posted December 23, 2019 If the problem is only the overflying, your barometric altitude is too low. It does not have AGR mode yet so CCIP is based off barometric altitude It's not main problem, main problem is disabled settings for the aircraft's gun (crash avoidance altitude and etc.. ) after switching into AG mode, click on "gun" button and then on "feed" and it's broken in MP only. Overshoot bullets over target using gun reticle is only side issues. Same action in SP mission don't have this issue. 50+ DCS World mods. Russian Falcons Club Link to comment Share on other sites More sharing options...
Recommended Posts