Wingnutt270 Posted March 30, 2019 Share Posted March 30, 2019 (edited) The cockpit labels are fuzzy and completely illegible in VR, even with HMD res set to 1.5 in the rift. is there a fix? Edited March 30, 2019 by Wingnutt270 Link to comment Share on other sites More sharing options...
Buckeye Posted March 30, 2019 Share Posted March 30, 2019 It’s the Rift that’s the reason it’s fuzzy, not the cockpit. Sent from my iPhone using Tapatalk VR Cockpit (link): Custom Throttletek F/A-18C Throttle w/ Hall Sensors + Otto switches | Slaw Device RX Viper Pedals w/ Damper | VPC T-50 Base + 15cm Black Sahaj Extension + TM Hornet or Warthog Grip | Super Warthog Wheel Stand Pro | Steelcase Leap V2 + JetSeat SE VR Rig: Pimax 5K+ | ASUS ROG Strix 1080Ti | Intel i7-9700K | Gigabyte Z390 Aorus Master | Corsair H115i RGB Platinum | 32GB Corsair Vengeance Pro RGB 3200 | Dell U3415W Curved 3440x1440 Link to comment Share on other sites More sharing options...
Wingnutt270 Posted March 30, 2019 Author Share Posted March 30, 2019 (edited) Negative, this is completely different, its not the rift's resolution, the F18, P51, AV8, A10 (A and C) have legible and readable cockpits under the same settings. Even if you zoom in on the panel its illegible, very very blurry SEE ATTACHED Edited March 30, 2019 by Wingnutt270 Link to comment Share on other sites More sharing options...
arturojgt Posted April 2, 2019 Share Posted April 2, 2019 Hi, did you check the texture option in the options menu? I have the cv1, it’s a little blurry but when you make zoom is aceptable. Killing time in the bathroom, honey bring me some matches...fewwwwww. Arturo "Chaco" Gonzalez Thomas Link to comment Share on other sites More sharing options...
some1 Posted April 2, 2019 Share Posted April 2, 2019 Shouldnt look like that, check dcs texture options. Hardware: VPForce Rhino, FSSB R3 Ultra, Virpil T-50CM, Hotas Warthog, Winwing F15EX, Slaw Rudder, GVL224 Trio Throttle, Thrustmaster MFDs, Saitek Trim wheel, Trackir 5, Quest Pro Link to comment Share on other sites More sharing options...
cercata Posted April 2, 2019 Share Posted April 2, 2019 It happened to me on the F-5 when using Low res Textures, I had to use High res textures. It seems belsimtek used untralow resolution for the textures on low settings Link to comment Share on other sites More sharing options...
Recommended Posts