isaac mcpeek Posted September 26, 2019 Share Posted September 26, 2019 I seem to be having the classic F-5 Trim problem,ever since I've bought the Module . I have reinstalled it. I have removed force feed back. I have made sure it is mapped correctly and not duplicated twice or the key was assigned under UTI which would over ride any other attempted command. I HAVE ALSO TRIED RETURNING THE COMMAND BACK TO DEFAULT. It sticks in the either up or down position even if using the keyboard default command. The only thing that works is to not map it to anything but only use the clickable mouse command in the cockpit on the hat on the flight stick in game. I have checked to make sure it was mapped correctly and even check the axis command but there are no trim axis commands for the F-5. My flight stick a X-55 doesn't do this with any other module or flight sim. ONLY BELSEMTIK'S F-5 TIGER II. The F-86 doesn't have this problem. I have also tried other flight sticks. Same problem but only with F-5. HELP NOTHING WORKS. Link to comment Share on other sites More sharing options...
tom_19d Posted September 27, 2019 Share Posted September 27, 2019 A couple guys here had some ideas for this problem. I also seem to remember a gent that found unchecking “sync HOTAS at start” helped, along with the FFB unchecked as you mentioned. Terrible problem to have because it seems SO random. Also super basic but have you done a repair on your DCS? Multiplayer as Variable Asus Z97-A - I7 4790K - 32 GB HyperX - EVGA GTX 1080 Ti - Corsair 750i PSU TM Warthog HOTAS - TM Cougar MFDs - CH Pedals - TrackIR 5 - Samsung RU8000 55” Link to comment Share on other sites More sharing options...
bbrz Posted September 30, 2019 Share Posted September 30, 2019 If the joystick is off center you have to recalibrate and/or increase the deadzone. Btw, why are you posting the same problem in three different threads? i7-7700K 4.2GHz, 16GB, GTX 1070 Link to comment Share on other sites More sharing options...
cronustr75 Posted September 30, 2019 Share Posted September 30, 2019 Sorry, I opened a new thread, deleted here. Link to comment Share on other sites More sharing options...
Recommended Posts