sll Posted January 20, 2019 Share Posted January 20, 2019 After the last update I am unable to see the afterburner flame? Throttles at 100% tested with joystick hotas as well as keyboard? Wondering why... Link to comment Share on other sites More sharing options...
Moafuleum Posted January 20, 2019 Share Posted January 20, 2019 Maybe your physical throttle is at 100% but not the virtual one. If you have the finger lifts mapped, use them. You can also set the afterburner behavior in the options tab. Personally, i have it set such that i always have to use the finger lifts to activate the burners. This gives be a better control. You can also set it up such that with throttle full forward, you have the afterburner activates. The behavior changed a few updates ago Link to comment Share on other sites More sharing options...
falcon_120 Posted January 20, 2019 Share Posted January 20, 2019 Ctrl+Enter to see your throttle response. If it doesn't go over the mil power threshold is because you have the "use afterburner detent" ticked in the F18 option menu. Link to comment Share on other sites More sharing options...
sll Posted January 20, 2019 Author Share Posted January 20, 2019 Ctrl+Enter to see your throttle response. If it doesn't go over the mil power threshold is because you have the "use afterburner detent" ticked in the F18 option menu. Yes , it was the afterburner detent mapped, all good now. I guess I could also map finger lifts Thank you so so much for the help!:thumbup: Link to comment Share on other sites More sharing options...
Recommended Posts