Launching Mav's

What is the key press for firing the Mav's

Ralt + Space drops bombs and Space fire everything else.....cant seem to fire the Mav's after getting a good lock! :)

This is on FC2.

Cheers

What is the key press for firing the Mav's

 

Ralt + Space drops bombs and Space fire everything else.....cant seem to fire the Mav's after getting a good lock! :)

 

This is on FC2.

 

Cheers

Keep the Weapons-Release Command depressed until release. Takes a sec or two.

Welcome back MrWolf - it's been awhile :)

Hello and welcome again Mr. Wolf, long time no see. :)

To fire all missiles in FC2 you need to hold the fire down for a couple of seconds. This is trying to simulate real aircraft.

You have the correct keys for firing them, space or Ralt+space, so they should fire if you hold the button down for a few seconds.

I can only assume that you are not within firing parameters ???

Once you push enter to stabalise the seeker, and then actually bring the crosshairs onto a target, only once the pointing cross on the TVM flashes will the missile be able to fire.

This is copied from the manual.

Once you have the pipper near a target, press the [Enter] key to stabilize the seeker on that terrain point. This will ground stabilize the seeker. You can then use the slew keys to place the HUD reticule / TVM targeting cross on the target. If in range, the seeker will "snap to" to the target and lock it. It will then track and maintain lock as long as it can. When the pointing cross on the TVM flashes, it indicates that you have a valid lock and can fire the missile.

That being said, when I first installed FC2, my weapons would not fire at all, at first I thought I was doing osmethign wrong which I wasnt, I knew that the vihkr launching had changed for the 25t in fc2, but I was doign it correct but still they wouldnt fire.

I reinstalled and it has worked smoothly ever since.

aha then its my X52 that doesnt like Ralt+Space, anyone know a work around to map it to my Saitek Profile?

Thanks for the welcome guys, its been a while.

aha then its my X52 that doesnt like Ralt+Space, anyone know a work around to map it to my Saitek Profile?

I've just remapped the Weapons Release keypress to [up Arrow]. Just remember to do it with all relevant Airframes as each aircraft now has it's own set/list of inputs.

thanks! :)

aha then its my X52 that doesnt like Ralt+Space, anyone know a work around to map it to my Saitek Profile?

 

Thanks for the welcome guys, its been a while.

I had to remap a whole host of Ralt and Rshift buttons in my X-52 profile to get them to respond.

The new x52 software recognises right alt now.

The old sst software and drivers didnt.

Mr Wolf is back :]