xxJohnxx Posted September 19, 2017 Share Posted September 19, 2017 The "Direct-To button" seems to be missing two of the key functionalities: 1) Whenever a Airport Identifier, Waypoint or Navigation Aid (from now on called waypoint) is highlited (blinking), like for example in the NRST Page, pressign the "Direct-To button" should bring up the "Direct-To Page" with the previously highlited waypoint allready selected. However, with the DCS: NS 430, pressing the "Direct-To button" while having any waypoint selected does bring up the "Direct-To page", however, there is no waypoint preselected. This makes the NRST page quite useless, as you still have to enter the waypoint identifiers manually. 2) After setting a Direct-To route, bringing up the "Direct-To page" (without having any waypoint identifier selected (see point 1)) should show the current Direct-To waypoint, allowing the operator to quickly re-activate the same waypoint, plotting a new Direct-To route. This however, is not the case in the DCS: NS 430. Bringing up the "Direct-To page" while allready flying directly to a waypoint, shows an empty Direct-To waypoint, forcing you to re-enter the same waypoint you are allready heading too. This functionality is immensely useful while flying VFR and only using the NS as a loose direction reference and is desinged like that in every Garmin navigation system. Check out my YouTube: xxJohnxx Intel i7 6800k watercooled | ASUS Rampage V Edition 10 | 32 GB RAM | Asus GTX1080 watercooled Link to comment Share on other sites More sharing options...
gospadin Posted September 19, 2017 Share Posted September 19, 2017 These are both already reported, thanks. My liveries, mods, and missions for DCS:World M-2000C English Cockpit | Extra Beacons Mod | Nav Kneeboard | Community A-4E Link to comment Share on other sites More sharing options...
Recommended Posts