TuffAsAir Posted December 16, 2019 Share Posted December 16, 2019 When the 'MAL & IND LTS' are set to DIM, if you turn the console flood light knob to the maximum brightness, or close to the max, the 'MAL & IND LTS' revert to the brightest setting. If you then click and hold the switch towards the DIM position, they go dim but upon release of the switch, they revert to the bright setting. If you lower the brightness of the console flood lights enough, it is possible to set the 'MAL & IND LTS' back to DIM setting. When the 'MAL & IND LTS' are set to DIM, if you turn the primary 'INST PNL' knob all the way to the minimum, the 'MAL & IND LTS' revert to the brightest setting. Clicking the the switch towards DIM(or clicking and holding it) does not change the brightness level of 'MAL & IND LTS'. With 'INST PNL' brightness set to any level except the minimum, it is possible to set 'MAL & IND LTS' to DIM. I have searched to find whether or not this is the intended behavior, but have been unable to find detailed info on the subject. Track attached.MAL & IND LTS switch.trk Link to comment Share on other sites More sharing options...
ED Team BIGNEWY Posted December 16, 2019 ED Team Share Posted December 16, 2019 Reported, thank you Forum rules - DCS Crashing? Try this first - Cleanup and Repair - Discord BIGNEWY#8703 - Youtube - Patch Status Windows 11, NVIDIA MSI RTX 3090, Intel® i9-10900K 3.70GHz, 5.30GHz Turbo, Corsair Hydro Series H150i Pro, 64GB DDR @3200, ASUS ROG Strix Z490-F Gaming, HP Reverb G2 Link to comment Share on other sites More sharing options...
F16FLCS-SME Posted September 21, 2020 Share Posted September 21, 2020 MAL & IND LTS BRT/DIM switch logic According to this post, it is still under the status of "REPORTED". https://forums.eagle.ru/showthread.php?t=258034&highlight=MAL+IND+LTS+Switch The correct logic according to -1 is: "If the PRIMARY INST PNL knob is on, momentary activation of the switch to DIM places the lighting system to the dim condition. The system automatically returns to the BRT condition if the FLOOD CONSOLES knob is turned past the detent to HIGH INT, if the PRIMARY INST PNL knob is turned off, or if emergency dc power is lost. So, the status of the OP bug report should be changed to "NO BUG". Link to comment Share on other sites More sharing options...
Recommended Posts