Jump to content

A/G DES don't work on Computer Pilot with TCS on TV


riojax

Recommended Posts

  • 2 weeks later...

From my experience with Computer Target, I use the VSL controls to move the designator diamond up and down the fall-line (TCS slaves to the ◇), and when you're within 10 miles slant-range, command PAL to lock the computer to that position.

REAPER 51 | Tholozor
VFA-136 (c.2007): https://www.digitalcombatsimulator.com/en/files/3305981/
Arleigh Burke Destroyer Pack (2020): https://www.digitalcombatsimulator.com/en/files/3313752/

Link to comment
Share on other sites

  • 2 months later...

Please view the cc initial point bombing tutorial video from jabbers, perhaps it shows you something you may have missed.

[sIGPIC][/sIGPIC]

 

Commodore 64 | MOS6510 | VIC-II | SID6581 | DD 1541 | KCS Power Cartridge | 64Kb | 32Kb external | Arcade Turbo

Link to comment
Share on other sites

Hey Spurts, I tested it extensively in the past few weeks as I built the watching the devildog mission around it. It really works flawlessly here on my side as well. So I would suspect that there is some kind of pilot or user error involved. Would you be so kind and record a video that shows all the steps you do.

 

Are you using any mods, btw? Or did you use any mods lately that you did not fully remove manually? Just trying to exclude stuff. Are you using target des fwd to lock the diamond? Are you sure you are within range?

 

I am just asking all these questions to brainstorm a bit. Note I do not want to fully exclude yet that it is a bug only some experience. It is not the first time, although it often involves some specific change on the client's part as well. Lastly it could be that the button you have t des fwd mapped to is malfunctioning.

Heatblur Simulations

 

Please feel free to contact me anytime, either via PM here, on the forums, or via email through the contact form on our homepage.

 

http://www.heatblur.com/

 

https://www.facebook.com/heatblur/

Link to comment
Share on other sites

Iron Mike,

 

I appreciate the reply. I will try and upload something later today. I have no mods. I have tried two different Target Des FWD HOTAS inputs with the same result.

 

As I said I will try again. I appreciate the help in rooting out if this is user (my) error.

Link to comment
Share on other sites

Pilot bombing works fine for me when flying multicrew. Designating ground targets does not work in IP bombing mode when flying multicrew though as I further explained here just recently: https://forums.eagle.ru/showpost.php?p=4030317&postcount=10

Intel i7-12700K @ 8x5GHz+4x3.8GHz + 32 GB DDR5 RAM + Nvidia Geforce RTX 2080 (8 GB VRAM) + M.2 SSD + Windows 10 64Bit

 

DCS Panavia Tornado (IDS) really needs to be a thing!

 

Tornado3 small.jpg

Link to comment
Share on other sites

Okay so after further review this was 100% an issue with the meat servo. Something I took note of this time, when out of range the diamond flashes, when in range it is steady. I must have been too high and far when I tried before, but I will pay attention to flashing diamonds now. Thanks for your patience.

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...