badbud Posted May 28, 2017 Share Posted May 28, 2017 Can any Saitek x52 Pro users give me Axis settings that work well for them? My taxi driving sucks and I can not find settings that make it any better. Thanks, BadBud Link to comment Share on other sites More sharing options...
mkiii Posted May 29, 2017 Share Posted May 29, 2017 I normally use a Warthog, but have an X52pro to try... I'm not sure axis settings will help that much with taxying, but keeping the stick fully back, and not raising the rpm above 1500 will help enourmously. Also, be sure to tap the brakes when turning, and recentre the rudder. Apply a little opposite rudder and brake once you are turned to straighten up. Remember that you have no direct control over the tailwheel, and it has to be prompted to get it straight again. Do you have pedals, or are you using the X52 twist stick? If the twist, then having just tried it with my X52, a curve of about 20 to 30 might help with the fine control, and perhaps a small deadzone of 4 on the rudder axis. It's not easy with the twist when you have to hold the stick back, twist, brake and manipulate the trottle all at the same time. Pedals make this a lot easier. I normally use CHPro pedals, and use the following for my rudder:- Deadzone = 4, SaturationX = 100, Saturation Y = 80, Curve = 34 Link to comment Share on other sites More sharing options...
badbud Posted May 29, 2017 Author Share Posted May 29, 2017 Have tried many Axis settings without any luck and you are most likely right...........it does not help. I also use CHPro rudder pedals. Will keep trying and hoping that a Spit patch will come along to ease the problem. Thanks, BadBud Link to comment Share on other sites More sharing options...
equinox74 Posted December 9, 2018 Share Posted December 9, 2018 Hi There, I don't suppose you have a profile I can use for the x52? I am struggling setting one up! :) Many Thanks! Link to comment Share on other sites More sharing options...
Recommended Posts