MPCD ok in this Campaign?

Hey good folks, not sure if it was me or something wrong with this equipment in the 3rd mission of the Aggressors BFM campaign. I can't seem to get the MPCD showing the MAP to come on at startup or anytime after in fact. Am I doing something wrong, checked the manual but no dice?

:book:

https://r.tapatalk.com/shareLink/topic?url=https%3A%2F%2Fforums%2Eeagle%2Eru%2Fshowthread%2Ephp%3Ft%3D246917&share_tid=246917&share_fid=74365&share_type=t

Sent from my SM-A530W using Tapatalk

https://r.tapatalk.com/shareLink/topic?url=https%3A%2F%2Fforums%2Eeagle%2Eru%2Fshowthread%2Ephp%3Ft%3D246917&share_tid=246917&share_fid=74365&share_type=t

 

Sent from my SM-A530W using Tapatalk

Thanks for that Darc, I didn’t know there was a problem with the moving map beforehand.

I'm not sure if its related the the campaign or not as it worked fine a few updates ago. I haven't run a cold start in any other missions in a while.

The UPD - TCN - ACPT work for me last night on mission 4 vs F-4E. Just make sure to set your tacan to ON and 12X.

The only odd thing I noticed is that the egress waypoints terminated after about half way so I had to fly visual for the last 35nm.

It's still very much WIP I think we're a ways off until we get a fully simulated nav system.

Sent from my SM-A530W using Tapatalk

 

The only odd thing I noticed is that the egress waypoints terminated after about half way so I had to fly visual for the last 35nm.

I believe this is related to the limitation of the maximum number of sequenced waypoint that the F18 mission computer can handle, If you want the missing last route WP try to add them in sequence (this will remove the first ones...)

I believe this is related to the limitation of the maximum number of sequenced waypoint that the F18 mission computer can handle, If you want the missing last route WP try to add them in sequence (this will remove the first ones...)

Sent from my SM-A530W using Tapatalk

No, you will need to fly unsequenced as seq2 does not contain these waypoints. One would need to enter them manually to seq2 for now, but I understand this is coming later for the Hornet.