Jump to content

[FIXED]Rocket ripple fire not working


escaner

Recommended Posts

Yesterday I was on a mission with rockets in the F-5E. Before startup I selected in the kneepad 60 ms interval in both rocket types, as I was not sure which ones I had loaded (I had four Mk.151 7 rocket pods).

 

For the ground attack, I selected the two inner pylons, set "Rocket" in the A/G mode and when I hold the pickle button, only one pair came out. Of course, I expected all seven pairs to fire on the set interval. In the end, I needed one press for each pair.

[sIGPIC][/sIGPIC]

Link to comment
Share on other sites

  • 2 weeks later...

I have been researching this problem. It only happens when I manually configure rocket ripple 60ms before starting the airplane. When it is already configured from the mission editor, it works fine.

 

The behavior is that the first press (and hold) of the pickle button will work as rocket single fire. Next presses will work as ripple fire.

 

Besides I noticed that the old bug with LAU-3 firing 2 rockets in single mode is still there.

 

Both bugs are demonstrated in the following video:

 

1. First pickle press -> both bugs at the same time: works as single but 2 rockets launch from each pod

2. Second pickle press -> ripple works.

 

[sIGPIC][/sIGPIC]

Link to comment
Share on other sites

  • 4 weeks later...
  • 5 months later...
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...