ED Forums - View Single Post - 3D Printed Cyclic
View Single Post
Old 09-01-2019, 05:42 PM   #3
Sokol1_br
Veteran
 
Sokol1_br's Avatar
 
Join Date: Apr 2007
Posts: 3,829
Send a message via MSN to Sokol1_br
Default

You want a grip with more buttons for you "BI8" cyclic?

Just buy a used CH Figherstick in Ebay and use their grip, is 16 buttons + POV HAT, will cost less than 3D print a grip and install switches and HAT - part not available, unless $80+ "military" models.


But, keep in mind that the controller on your "BI8" need support the extra buttons of the new grip, or you end need use a Arduino, Bu0836 for manage extra buttons, what make you cycle two controllers for Windows and games.

In this case became interesting get any of VirPil grips, that is easy connect in Arduino PRO Micro + MMJoy2 firmware for serial protocol for grip Shift Register.

Last edited by Sokol1_br; 09-01-2019 at 05:50 PM.
Sokol1_br is offline   Reply With Quote