Snappy Posted February 15, 2019 Share Posted February 15, 2019 (edited) Hello everyone, I have two questions: The manual for the F-15C mentions on page 67, quote: "Along the bottom of the VSD is a horizontal scale that reflects the selected azimuth scanning zone width. The width defaults to - ±600, but by pressing the [RCtrl+-] key, - ±300 can be selected" However I am having trouble finding that key binding for changing scan zone width.For whatever reason the default "RCtrl+-" is not assigned and I can't seem to find any action for scan zone ,width, azimuth or similar key words. If someone could kindly tell me under which action I can assign a key or joystick button to it that would be nice. -------------------------------- The second question is, again in the manual (pages 51&52)it states and also is shown in screenshots that with a radar locked target in either Gun Director sight mode or Aim 9 radar slaved mode in the very bottom left corner of the HUD , below the own mach no / AOA there should be a line with the target mach no of the locked target. However this is simply not visible on my system with a ltarget in STT , neither in GDS nor the radar aim9 lock mode. This is the standalone module version. Is this a bug or am I missing a step somewhere? Thanks a lot in advance , Kind regards, Snappy Edited February 15, 2019 by Snappy Link to comment Share on other sites More sharing options...
GGTharos Posted February 15, 2019 Share Posted February 15, 2019 You're not missing anything. It was removed, basically the system is not considered to be operating in the V/S mode any more, so this information is removed. [sIGPIC][/sIGPIC] Reminder: SAM = Speed Bump :D I used to play flight sims like you, but then I took a slammer to the knee - Yoda Link to comment Share on other sites More sharing options...
Snappy Posted February 16, 2019 Author Share Posted February 16, 2019 GGTharos, is your answer a reply to my first or second question? Kind regards, Snappy Link to comment Share on other sites More sharing options...
feefifofum Posted February 16, 2019 Share Posted February 16, 2019 Hi Snappy. Tharos is replying to your second question. As for your first, the bindings are called "scan zone increase" and "scan zone decrease." They are indeed "Rctrl -" and "Rctrl =" When in RWS, you should see the width of the scan change. THE GEORGIAN WAR - OFFICIAL F-15C DLC Link to comment Share on other sites More sharing options...
Snappy Posted February 16, 2019 Author Share Posted February 16, 2019 Feefifofum, thank you, but unfortunately those bindings do not exist on my system. There is only scan zone left,right, up, down. No "increase" or "decrease" Kind regards, Snappy Link to comment Share on other sites More sharing options...
draconus Posted February 17, 2019 Share Posted February 17, 2019 It's "Predicted target range inc./decr." to be exact :) Win10 i7-10700KF 32GB RTX3060 Rift S T16000M TWCS TFRP FC3 F-14A/B F-15E CA SC NTTR PG Syria Link to comment Share on other sites More sharing options...
Snappy Posted February 19, 2019 Author Share Posted February 19, 2019 Draconus, thank you very much! That did the trick :-).Very good camouflaged key bindings ;-) Kind regards, Snappy Link to comment Share on other sites More sharing options...
Recommended Posts