ED Forums - View Single Post - Shkval targeting system slewing
View Single Post
Old 11-19-2017, 12:26 AM   #7
PeaceSells
Member
 
Join Date: Dec 2016
Location: getSelfCoordinates()
Posts: 540
Default

Quote:
Originally Posted by Frederf View Post
Diagonal motion with hat switch depends on your controller. It will move diagonally if two buttons are pressed at the same time. If your diagonal hat ouputs two buttons when diagonally pressed it works fine. If your diagonal hat outputs a separate button then it won't.

There are two fixes for this: Use joystick programming software so diagonal press instead outputs the nieghboring vertical/lateral buttons at the same time.

Two, bind the 8 outputs (A B C D E F G H) to the 4 directions like this:
Up H A B
Right B C D
Down D E F
Left F G H
Of course this is impossible in the GUI but I think it can be done with text editing. The lines in DCS will have red highlights because it thinks multi-binding is a problem.
Yes, what I do is use TARGET to generate the 'Thrustmaster Combined' and set the throttle's POV hat as the 'Trustmaster Combined' POV hat and set the stick's POV hat as 4 normal buttons. This way I can use the stick's POV hat as the shkval slew, because I also like to have it on the stick, like the real chopper.

The stick on the T16000M only has one hat and it's a 8-way hat... Would be nice if ED made the shkval work normally with 8-way hats, would save you from having to use profiling software...
__________________
My DCS modding videos:
https://www.youtube.com/playlist?lis...vOUdZRNh3y3Un3

Modules I own so far:
Black Shark 2, FC3, UH-1H, M-2000C, A-10C, MiG-21, Gazelle, Nevada map
PeaceSells is offline   Reply With Quote