Jump to content

TM Warthog CMS button not registering


raybanman

Recommended Posts

After a couple months binging on the Harrier and Hornet, I went back to my baby, the A10C, and wanted to move some mud.

 

 

Everything working fine (quick TDC rebind, and Throttle off rebind for some reason), except CMS FWD and CMS DN, don't work. In Options, they are mapped to the correct buttons, but when I clear and try to re-map DCS doesn't seem to detect the button action and it won't assign it (Button 15, and 19 I believe). Checking in windows controller properties the buttons work fine, and they work fine in a few other games I tried, as well as registering in TARGET when I start it up and run the event tester. (I'm using default DCS binds and not running a TARGET profile either).

 

 

Running OpenBeta, 2.5.2.18521

 

 

Any ideas?


Edited by raybanman
Issue Solved.

-Raybanman "Slim"

Link to comment
Share on other sites

You could perhaps try deleting the .diff.lua file for the joystick in c:/users/username/saved games/dcs.whatever/config/input

 

Since DCS automatically populates controls for the TMWH stick and throttle this should pull the default profile and hopefully correct the issue for you. If the keypress is registering in Windows it should show up in DCS.

 

People have reported issues with unpowered USB hubs, so you might also try plugging your stick directly into the PC as a test if you're using one of those.

Link to comment
Share on other sites

[sOLVED]

 

 

I had assigned HMD recenter and VR zoom while flying the Hornet (they are unused in my hornet profile) to those two buttons in UI layer. The conflict doesn't show up when you try it in DCS. I removed the bind (may add a modifier and keep the bind later) and they work fine now!

-Raybanman "Slim"

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...