Jump to content

X56 profile


Recommended Posts

How do you enable/use the after burner?

I push the throttle all the way and it does not turn on.

RMP does not go above %100

i do not have any dead zones on my x56 throttle

 

afterterburner doesnt make your rpm higher, it will just inject fuel in the nozzle and with the hot air, it will burn and create more thrust

 

just notice that the fuel flow will significantly increase when you at full forward position

Link to comment
Share on other sites

it doesn't...

in another simulator i use (bms) you can set. on the throttle, when the afterburner will start working.

I also see that the fuel flow, as you implied , significantly increases there and rmp reached %120

However, in DCS max rpm is %100 and fuel flow does not significantly increase (for me) when i put the x56 throttle in it's max fwd position.

 

So how do i set the MIL position of the throttle?


Edited by karpiyon
Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...