Redeye

Hey Deltaalphalima1 I received the unit today. Should have waited one more day before contacting you. Tab"Redeye"Harris

Merry Christmas everybody and a happy 2019!

Please add me to the list.

Order #1447

I tried the shapeways detent but found it too hard to push through for formation flying. I could shave it but ... I use the original WH detent in the no detent position but first i put a toothpick under it. This lifts the detent up and gives a slight bump. Mine hits at mil power and is a easy push through without lifting. Experiment with different thickness of whatever you have around. Note: there is less material making contact in the no detent position.

In case you haven't seen this one. http://obutto.com/gaming-cockpits/r3volution-gaming-cockpit/

RIP Igor. Thank you for DCS world!

I had to change the keystrokes for 2 of the sensors. I think they were Lwin+Y and LWin+U. All other sensor keystrokes worked fine. I now use LShift+Y and LShift+U and all is good.

Position yourself the way you want then hit numpad 5 to reset your view.

Check the AV8BNA Pocket Guide.pdf located in your install folders. C:\Program Files\Eagle Dynamics\DCS World 2 OpenAlpha\Mods\aircraft\AV8BNA\Doc Look at page 7 item 7. The Throttle Cutoff Lever is hidden between the parking brake and throttle.

Here is the thread on how to roll back to different versions of DCS. https://forums.eagle.ru/showthread.php?t=114030

Check this out. https://forums.eagle.ru/showthread.php?t=152612&highlight=phantom+control

Andre When everything fails .... read the instructions again. Everything is working like it should. Thank you.

I will try a DCS module but i get this error before i get a chance to select an aircraft. And the last error (small one) after i exit DCS.

I recieved my jetseat and i have a problem. I tested and all works on massage but i'm getting an error when trying in DCS.