equinox_echo

Same same , it used to work without this step for me too. Enjoy the festival :-) Envoyé de mon SGP612 en utilisant Tapatalk

Hi mr_mojo97, I had this exact same issue and did find a trick on YT. Before pushing the engine start switch, you need to push the 'engine shutdown button' (id.35, pages 18 & 21 in the manual). It is a small red push-button without any label, at the right of the throttle on the cosole. Give it a try Cheers

MP envoyé ;-)

Salut Vitaliq, Pour ton budget ca risque d'etre dur de trouver du neuf. Le T16000M est un très bon stick. Pour le throttle, essaye de trouver en occaz: -X-55 / throttle seul - Warthog / throttle seul (à moins de 100 euros c'est pas gagné) - CH Pro Throttle A+

Salut, Dispo en journée pour DCS (P-51, Huey, Mig-21, M-2000C) A+ Echo

Take-off and landing M-2000C I have the same issue, even for v 1.5;v 2.0 is a lot worse though. It could well be cross-wind but it does not feel like it. During take-off, the issue starts at approx 90 kts when rolling ( at 0:40 in the following vid) [ame= ] [/ame] Same issue with landing with constant right rudder for a steady landing. Normally with cross-winds your rudder input should depend on plane airspeed.... Echo

Hi guys, Not sure it is a bug but I faced a stange issue during a nav training session. All was fine until I lined up for landing at Krasnodar-Center, runway 27. See starting at 04:00 It looks like the LOC is shifted sideways to the left. I have done another test, switching on the Auto Landing mode for a while with the same results. Any idea ?

Thanks cliffy229, I can now log in with 1.2.12 beta :thumbup: but not the official release

No joy on my side, with all JSGME mods disabled , and after a DCSW repair... Any idea ?