CAMERAMAN

Yip! Same Sent from my SM-N960F using Tapatalk

R.I.P

Solved! Thanks again Harker. Sent from my SM-N960F using Tapatalk

Many thanks Harker. My pc crashed & I have not been in tune with updates etc for some time. Will try your suggestion. Sent from my SM-N960F using Tapatalk

Please can someone assist. My trackIR freezes when the red symbol appears. Seems to be locking onto a craft. Have I missed something in settings?

To create a countermeasure program: a) Press the OSB next to ARM b) Configure Chaff by pressing the OSB next to CHAF, then use the Increment/Decrement OSBs to set the desired number c) Configure Flares by pressing the OSB next to FLAR, then use the Increment/Decrement OSBs to set the desired number d) Configure the number of repetitions by pressing the OSB next to RPT, then use the Increment/Decrement OSBs to set the desired number e) Configure the interval time (sec) by pressing the OSB next to INT, then use the Increment/Decrement OSBs to set the desired number f) Press the OSB next to SAVE to save countermeasure program 1 Sent from my SM-N960F using Tapatalk

Create on a different drive or create another folder Sent from my SM-N910C using Tapatalk

For some reason I cannot get. 1.5d to function with the jtac training mission supplied with the mod. Am I missing something? I installed 1.5d as instructed into jsgme. Any advice would be appreciated

Hi. I installed the latest version 1.5 d. I installed all three folders to jsgme & activated "main" & ka 50. I did this a few times, but still get the old R828 F9 for JTAC. Not sure where I'm going wrong.

Such amazing memories. RIP Blooze

Well said Jack. Thanks for bringing this devastating news to our attention RIP Blooze. We're going to miss you!

Thanks - I have discovered what you were saying about main radio & aux radio key bindings being switched. So this is what I have deduced. MAIN RADIO - (V/UHF) LSHIFT+NUM+ - AMPLITUDE SETTING (COM 1) FOR GENERAL COMMS AUX RADIO - (UHF) LALT+NUM- MUST BE ENTERED TO SWITCH TO UHF MENU. USING (\) WILL OPEN THE UHF COMM MENU - AMPLITUDE SET TO (COM2) FOR UHF TO SWITCH BACK TO MAIN MENU HIT L/CTRL+\ FOR v/UHF & AMPLITUDE SET TO (COM1)

TomCatMucDe -What key bindings are you using Aux & main? :helpsmilie:

Ok, I`ve tried selecting COM 2 amplis & hitting (\). Surely this should bring up the UHF communication menu & not V/UHF? I`ve missed something I`m sure. Toggling the amplis to either COM 1 OR COM 2 does nothing - Wingmen do not respond!