raelias

As it should, but that's not what is been reported here. I absolutely should get spiked if I'm flying close-ish to the actual target, and it works pretty well in single player, but in multiplayer, if any allied get spiked by ground/sea based radars, you will be as well, no matter where you are, that's what this thread is about, and such a huge bug being around for 4 years is totally unacceptable

Please read the reports before writing nonsense Or you are telling me that asking for my rwr not to spike on the ground, in the other side of the map when an allied flight is spiked in the opposite azimith is asking to turn DCS into Ace Combat?

the main issue is that it happens from ground/ship based radars all the time and it's been 4 years

it's quite impressive that such a huge and annoying bug as this is around for 4 years isn't it?

Looks like that did it, thanks!

It was 50mb-5000Mb, (from troubleshooting an issue with another sim), I'll reset it to auto and see if it fixes it

So for some reason DCS started crashing for me when I go on missinos, usually right when I go into de cockpit or shortly after a couple minutes, what is werid is it USUALLY also crashes chrome and discord and just kind of hard freezes the whole PC, sometimes it recovers, sometimes not, altho there are a few instances of dcs crashing by itself I'm including the crashlog and dxdiag in hopes someone can help me identify the issue, there are no mods installed, and I tried a full repair Windows 11 Thank you for your help dxdiag.txt dcs.20220302-061504.log

Yeah it's fine this has just been around for 3 years

Might wanna rewrite the manual then

I can't slew the pod in AUTO mode tracking or not tracking, unless there is a special combinations of hotas commands I'm not aware of, that's what I'm trying to determine on this thread

I don't think so, this section of the manual is on ATFLIR tracking modes

Yes but the manual reads "The ATFLIR enters this mode when the pod is slewed while in AUTO mode. Then just below it says the TDC cannot be moved in AUTO mode. So which one is it?

I got some conflicting info onthe manual in regards to the auto (point track) mode, it references the INR AUTO mode which would in theory allow for slewing the ATFLIR and attemp the point track when done, very useful for quickly capturing another moving target But, just below that, it informos that you cannot slew the pod in AUTO mode, which is true, so My question is, how do I enter INR AUTO for slewing, since pressing on the TDC will enter the offset mode, or is this a manual error? Thanks

I really wished for a official statement on this

Well if the BRU-55 suports GBU-32, there is no reason why out lot 20 shouldn't have it