Announcement

Collapse
No announcement yet.

User Profile

Collapse

Profile Sidebar

Collapse
Gizzy
Gizzy
Member
Last Activity: 10-20-2020, 04:40 AM
Joined: 07-04-2015
Location: Tír na nÓg, Co ANTRIM
  •  
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • Gizzy
    replied to [REPORTED] TOT NOT WORKING
    Thanks, will do...
    See more | Go to post

    Leave a comment:


  • Performance is often equipment dependent.

    Syria does use more RAM.... but DCS maximises my 2080ti 100% most of the time in VR (HP Reverb = high res) which is great.... downside uses around 20-22 of RAM.

    High GPU % and high settings means sharp clear smooth play and for once
    ...
    See more | Go to post
    Last edited by Gizzy; 10-13-2020, 09:18 PM.

    Leave a comment:


  • Gizzy
    replied to TIME ON TARGET
    Sometimes works just fine point to point.... i.e. 1 WP but for me, never over a NSEC grouped WP route....
    See more | Go to post

    Leave a comment:


  • Gizzy
    replied to [REPORTED] TOT NOT WORKING
    Thanks for coming back Elmo. Yes, just tested test.miz on 2.5.6.55847 witht he same result.


    Just for info...


    ME gives

    WP1: CS 300GS 1:23
    WP2: CS 420GS 3:12
    WP3: CS 420GS 4.56
    WP4: CS 420GS 6:00

    Spawn time is 0400UTC...
    See more | Go to post

    Leave a comment:


  • Gizzy
    replied to [REPORTED] TOT NOT WORKING
    The point of the caret is to adjust your COMMAND SPEED to get within 1 minute of planned TOT.

    GS has always been correct in relation to the map with any TIME / DISTANCE calculation.

    TOT is simply broken.
    See more | Go to post

    Leave a comment:


  • Gizzy
    replied to [REPORTED] TOT NOT WORKING
    Ground Speed IS ALWAYS used for TOT - you cannot be accurate on IAS.

    The ME is set to calculate time for legs using GS


    Certainly you can do TOT manually with a table for times at the WPs in the kneeboard, that's how we used to do it...

    The TOT function in...
    See more | Go to post

    Leave a comment:


  • Gizzy
    started a topic [REPORTED] TOT NOT WORKING

    [REPORTED] TOT NOT WORKING

    Using NSEC or SEC TOT set in accordance with RAZBAM's txt file not working in that the COMMAND SPEED indicator progressively demands slower speed no matter what. It's manageable to the 1st WP and occasionally to the 2nd but but after that the indicator just demands a faster speed no matter what....
    See more | Go to post

  • Gizzy
    started a topic TIME ON TARGET

    TIME ON TARGET

    Has any one reliably managed to get TOT working either with NSEC or SEC routing... in accordance with RAZ's instructions
    See more | Go to post

  • Hi Razor - all good I hope?

    Correction Lever Increase & Correction Lever Decrease are NOT control axis, they are for buttons / switches and assign fine...

    Maybe you were just in the wrong screen or have a local module corruption as I'm sure you know.... in the AXIS ASSIGN...
    See more | Go to post

    Leave a comment:

No activity results to display
Show More
Working...
X