Jump to content

Help with WinWIng AB Calibration


sSkullZnBoneZz

Recommended Posts

Hey guys,

 

Just got my WinWing F/A-18C throttle today. Finally got it up and running and I flew all day with no issues. Later on, I decided to calibrate it. Now that I've calibrated the AB the throttle doesn't recognize the detent and goes full AB at max throttle. I have followed the vague instructions in SimAppPro to put both throttles in the AB at the same time, etc. I have tried setting the AB ratio and that's of no help. So now I'm stuck with trying to manually keep the throttles from going into afterburner.




Liquid Cooled i9 11900K | GeForce RTX 2080 | 32 gig RAM | SSD Samsung 850 EVO | HP Reverb G2

TM F/A-18 Stick | Virpil WarBRD | WinWIng F/A-18 HOTAS

Link to comment
Share on other sites

The throttle is calibrated from idle to max (thru the A/B stop)

 

The afterburner is calibrated from idle to the A/B stop

Ryzen 9 7950X3D - MSI MAG X670E TomaHawk MB, ASUS ROG Ryujin III 360 AIO

64gig Corsair DDR5@6000, Gigabyte GeForce RTX 4090 AORUS

Winwing Super Taurus, Orion2, TO / Combat panels, Collective with Topgun MIP

Winwing Skywalker pedals, NLR Boeing Mil Edition Simpit, Trackir

Link to comment
Share on other sites

The throttle is calibrated from idle to max (thru the A/B stop)

 

The afterburner is calibrated from idle to the A/B stop

 

Thanks, I was going from idle to mil. That fixed it.

 

 




Liquid Cooled i9 11900K | GeForce RTX 2080 | 32 gig RAM | SSD Samsung 850 EVO | HP Reverb G2

TM F/A-18 Stick | Virpil WarBRD | WinWIng F/A-18 HOTAS

Link to comment
Share on other sites

Winwing are apparently rewriting the UI, so hopefully things will be a tad easier!

  • Like 1

Ryzen 9 7950X3D - MSI MAG X670E TomaHawk MB, ASUS ROG Ryujin III 360 AIO

64gig Corsair DDR5@6000, Gigabyte GeForce RTX 4090 AORUS

Winwing Super Taurus, Orion2, TO / Combat panels, Collective with Topgun MIP

Winwing Skywalker pedals, NLR Boeing Mil Edition Simpit, Trackir

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...