Bob1943 Posted June 1, 2020 Share Posted June 1, 2020 My CH Pro rudder pedals are connected and recognized in the DCS "Controls" window. For each of my planes they are set as Joy_z for "Rudder" under the "Axis Commands" menu. There are no conflicts with other controllers, i.e., only the CH Pro Pedals column has a command assigned for rudders. However, when I go to takeoff, I have no rudder control in any of my planes. Any ideas as to why they are not working as programmed? Link to comment Share on other sites More sharing options...
Svsmokey Posted June 1, 2020 Share Posted June 1, 2020 Game vs sim mode ? 9700k @ stock , Aorus Pro Z390 wifi , 32gb 3200 mhz CL16 , 1tb EVO 970 , MSI RX 6800XT Gaming X TRIO , Seasonic Prime 850w Gold , Coolermaster H500m , Noctua NH-D15S , CH Pro throttle and T50CM2/WarBrD base on Foxxmounts , CH pedals , Reverb G2v2 Link to comment Share on other sites More sharing options...
Bob1943 Posted June 2, 2020 Author Share Posted June 2, 2020 Sim Mode. I unplugged them from the USB hub and then plugged them back in and they work fine now. They must "go to sleep" if they are not in continuous use, and will not wake back up unless the power is recycled to them via unplug/replug. Is this a known issue with CH pedals? Link to comment Share on other sites More sharing options...
Svsmokey Posted June 2, 2020 Share Posted June 2, 2020 Not to my knowledge , but windows will put usb's to sleep . Check usb power settings . 9700k @ stock , Aorus Pro Z390 wifi , 32gb 3200 mhz CL16 , 1tb EVO 970 , MSI RX 6800XT Gaming X TRIO , Seasonic Prime 850w Gold , Coolermaster H500m , Noctua NH-D15S , CH Pro throttle and T50CM2/WarBrD base on Foxxmounts , CH pedals , Reverb G2v2 Link to comment Share on other sites More sharing options...
Recommended Posts